new carb kit same problem.200s

[leevarnado]

rebuilt the carb with a new kit and still having the same problem.i can tighten the throttle screw in or out and it does nothing when running.i tried moving the clip on the needle up/down still doesn't fix it.i did all the proper cleaning to the carb,let it soak,gunk carb cleaner,high air pressure.i made sure i replaced the o rings and i use everything that was in the kit.anyone had this prob before and how did you fix it.

[Thorpe]

Throttle screw? What screw are you adjusting?

[leevarnado]

the throttle screw would be number 8 in the pic.


77377

[leevarnado]

i just tried a different carb and still the same problem.it runs and will idel but it foils a plug out in a few mins.

[Tri-ZNate]

Does the idle ever change when you move the Idle Ajectment Screw? The only thing I can think of is maybe you are putting the slide in 180 degrees off.

Since you tried another KNOWN good carb, I'd also say check your air filter and make sure it isnt clogged

[leevarnado]

slide is in correct,tried it without a filter ,still same thing.it will only run with the throttle screw all the way in,and it will idel like that.

[PaTriker]

Wrong slide maybe?

[AngusJustice]

Have the same problem on my 1980 185 and still haven't figured it out yet, Did the same as you and used a rebuild kit but it did not help .

[leevarnado]

Have the same problem on my 1980 185 and still haven't figured it out yet, Did the same as you and used a rebuild kit but it did not help .

this is the second 3 wheeler this has happen to me.sold the first and looks like ima have to tell this guy,hey man.i tried everything i could.

[Erics350x]

Adjust the mixture screw on the bottom front of the carb. If this is the second time this happened , the you are doing something wrong.

[leevarnado]

the bike was doing this when the guy brought it to me and i did adjust the air mixture screw.the bike will do this with any carb you put on it.

[leevarnado]

another question.could a weak intake valve be causing my problem.the guy that brought me the bike had someone attempt to rebuild it.they could never get it started.they bored the cylinder.i was also thinking that maybe the cylinder is to tight???

[TrailerRider]

I think improper valve adjustment may do this. What is compression like? Leaky head gasket/Intake Gasket?