Need help installing Sprock Cool Head

[tri-z monster]

I just recieved one of the Sprock Cool Head kits and I am having trouble getting the two larger orings to stay in place. Anyone with a little trick of the trade to make this a little easier.

Thanks,

Monster

[outtaline]

put some bearing grease on them it works for me

[Bryan Raffa]

fill grooves with grease,install O rings, and be ready to put it right on.

[dcreel]

I use Yamabond to keep the o-rings in place on a banshee cool head

[clutchcargo]

I didn't use grease or anything on mine, but it was a PITA. You need lots of patience.

[Mosh]

http://www.3wheelerworldforums.com/showpost.php?p=446732&postcount=160

[tri-z monster]

mosh, where did you get the hi tack from?

[Mosh]

Any good Napa or auto parts store should have it.

I like to gently stretch the 2 large o-rings a little too, so they dont try to roll out of the grooves.Then I Hi-Tack the groove lay the o ring in, and Hi-tack over the orings also.
I also put some Teflon Paste ( same as teflon plumbing, tape but soft and in a tube) around the head studs to stop any coolant from wicking up the threads.They should have that also.