yea mine was a bit worse, i thought it was gonna be like the one in another thread it had like half a piston and the sleeve was cracked and still ran lol
Got The Holeshot
Arm chair racerJust too addicted
yea mine was a bit worse, i thought it was gonna be like the one in another thread it had like half a piston and the sleeve was cracked and still ran lol
proud owner of a trx300ex quadand an 85 atc 70
At The Back Of The Pack
Arm chair racerFirst time rider
My eyes have been focused on the engine, I didn't even realize that I had an R fender on her. I do concur, I like the look of it.
It's not going to hone out, it's already .50 over. I found a nice cylinder and piston on ebay so I'm gonna roll with that for now. I figure this cylinder may end up being .80 to 1.0mm over. I will save it for a rainy day, possibly re-sleeve it.
Mr. postman dopped off some parts for me today, clutch cable, rear axle bearings and seals, gasket kit, drive chain, flywheel puller, cam chain. Just waiting for the cylinder/piston and my air filter. I hope to have some real progress by this weekend.
If it aint old I dont want it!
My feedback thread:
http://www.3wheelerworld.com/showthr...EEDBACK-FOR-dz
Current rides:
Street:
1989 Yamaha Venture Royale 1300
Trikes:
1979 Honda ATC110 sitting winterized
Reply With Quote