Tri Z pipe identification

[mpwrd3]

Hey guys need another part identified. This pipe is off the Tri Z that I just recently picked up, and I cant figure out what kind it is.

Thanks for your help!

James

[factoryX]

the bottem half looks like a dg pipe...

[Tri-Z 700]

Looks just like the Bassani that was on Ebay the other day. DG doesn't have the sectional pieces welded in like that one has.

[factoryX]

the bassani pipe is longer. http://3wheelerworldforums.com/attac...5&d=1203996012

[mpwrd3]

Who all made hand coned pipes for the tri z? I have been searching old threads but haven't found any matches.

[Mosh]

Who all made hand coned pipes for the tri z? I have been searching old threads but haven't found any matches.

Coned pipes are hard to identify for sure.

Some sectional makers for the Z would be..

1)CRF Crotch Rocket Factory (Which doesnt look like yours)They were shorter with a large chamber.
2)Klemm Research.(Once again different than yours)Larger cone sections.Search Klemm pipe
3)Jemco
4)CT racing.(Yours looks closer to a CT)
Like I said, identifying them is hard.

The Jemco was just made last year for the bigbore engine, but they made 250cc inframe pipes too for the Z..Search Jemco pipe and you will find pics of those.But Jemco used larger coned sections than yours.
http://www.3wheelerworldforums.com/s...ght=tri-z+pipe

CRF threads.
http://www.3wheelerworldforums.com/s...light=CRF+pipe

http://www.3wheelerworldforums.com/s...light=CRF+pipe

There arent any pics that I found on this site from a CT pipe.
But I have a Mag article with a CT pipe on a Z.
It resembles the pipe you have, but dont hold me to that.

[mpwrd3]

Thanks for the info Mosh! I will look into it.

[adcotton]

http://www.ebay.com/itm/1985-YAMAHA-...da04d4&vxp=mtr

This look familiar to anyone?

[MTS]

http://www.ebay.com/itm/1985-YAMAHA-...da04d4&vxp=mtr

This look familiar to anyone?

Not sure on the make...wana say cobra? But i run one like that on my bb z, very much a top end pipe!