cant get the axle out my 200x

**johnnyo** · 09-14-2009, 10:14 PM

Changing my bearings and can't get the axle out. Took out the stop ring and both nuts and can't get the collar next to the hub to slide off the spline on the axle. Tried penetrating oil and heat. Really stuck on. Any ideas out there would be very helpfull. Thanks, John.

**harryredtrike** · 09-14-2009, 11:24 PM

try a piece of wood and a big

and lots of penetrating oil

**Thorpe** · 09-15-2009, 01:59 AM

Hard wood preferably... I hate when you smack it with the sledge and your 4x2 breaks...

**200xman** · 09-15-2009, 07:06 AM

Bring it by and I guarantee I can get it apart.

**oscarmayer** · 09-15-2009, 09:04 AM

^ w/o damaging the axle right? :P

**AutoXer** · 09-15-2009, 09:59 AM

I just did mine....... good luck.... mine has a new axle and a new brake hub

**rdlsz24** · 09-15-2009, 10:14 AM

My axle actually came out pretty easy but the bearings in the swinger were another story weeeooo

Rob

**Dirtcrasher** · 09-15-2009, 02:19 PM

What KIND of heat?? Because if you can't get it cherry red, there is much less of a chance to get it out.......

**Russell 350X** · 09-15-2009, 06:51 PM

^^^I second that, mapp and propane torches are never enough. Get it cherry red, and a block of wood, and a BFH, and go to town.

**hancadam** · 09-15-2009, 08:51 PM

I actually had to cut mine of with a wheel grinder. My 86 200x was in superb shape otherwise. Even after cutting it in half in two places it still would come off. I literally had to chisel it off from at the point. It took me several nights to get it off.

I ended up using a 250r axle on my 200x after that.

**johnnyo** · 09-15-2009, 09:15 PM

Originally Posted by hancadam

I actually had to cut mine of with a wheel grinder. My 86 200x was in superb shape otherwise. Even after cutting it in half in two places it still would come off. I literally had to chisel it off from at the point. It took me several nights to get it off.

I ended up using a 250r axle on my 200x after that.

quick question, the collar with the two big nuts schould slide off the spline after you get that stop ring off, right? this fn things driving me nuts

**hancadam** · 09-15-2009, 09:34 PM

Yup, should slide right off. I have one in my hand right now.

**dexterr** · 03-25-2010, 05:37 PM

i Got That Problem too with my 85 200x, The Disc brake dont wanna come off

**Dirtcrasher** · 03-25-2010, 05:47 PM

HEAT HEAT HEAT!! OXY/ACET and HOT!! Banging on it cold will just bend the rotor and or rotor hub...........

Clean it spotless and put some waterprrof grease on there when you re-install.

Penetrating lubes are good for something, just not rusty parts

Heat is your friend...................

DC

Thread: cant get the axle out my 200x

Thread Tools

cant get the axle out my 200x

axle