First Time Rider
Arm chair racerNew to the board
My 250SX tank had some rust in it, so I tried using the KREEM kit on it. It got some of the rust out, but not all of it so I didn't use the final (coating) stage of the kit. So now I still have a rusty tank that needs to be treated and eventually painted. Does anybody here still do that stuff? I know SYKO did some amazing work in the past, but not sure if he's back in the game yet.
Thanks,
Andy
Check my feedback before buying from me
First time rider
You can use hydrofluoric acid and marbles and shake up your tank to loosen the rust or just let the acid sit over night. As far as painting goes the hardest part is going to be your clear coat. If I was still in school I could do it for you but I don't have the right tools for it now. I'm sure someone does though.
Good Luck
85 350x 12:1 piston and porting by "boosted96cobra"
4 85 tecates 1 runs
5 84 tecates none run
1 84 Yamaha Zinger, mildly ported & polished, milled, bored .25 over finally running
2 atc 90's just parts bikes
00 rm250
93 kx500
2 Honda 200m parts bikes
Power User
Roostin Away
Will a KREEM kit patch pin holes?
My ridez 110,110, Big Red, 185s, 70, 200, 250r!!!!
REQUEST YOUR ATC PART'S @ The 3 & 4 Wheeler Emporium
The Enthusiast.
Teaching quads a lesson
Maybe a redneck fix but it worked... I used the acid and a big handful of 1/4" nuts... bungeed the tank to my tractor wheel chains and went for a ride... all those sharp corners chewed the rust right off...
Reply With Quote
