New to the board
Arm chair racerNew to the board
i just bought my 200 x and it needed a new rear sprocket, i checked the front one and when i pulled the cover plate off i saw that it was welded on. who ever did it welded it on crooked, i don't think the shaft is bent. should i just grind the weld off or will i hurt the shaft
Power User
Got the holeshot
If the sproket is welded on, the shaft is probably already ruined - which is why they welded the sprocket on in the first place.
Might as well grind it off ans see what you have to deal with.
Got The Holeshot
Arm chair racerJust too addicted
You will need a sprocket,a shaft and a complete gasket kit....
1986 ATC500X
1985 ATC250SX
1985 ATC200X
1985 ATC250R
1986 ATC250R
1984 ATC250R
1981 ATC70
1984 ATC70
1985 ATC70
Custom built ATC70 / 250R laydwon swap
1986 ATC250SX FATCAT
New to the board
Arm chair racerNew to the board
is the shaft easy to change. i've never done one
At The Back Of The Pack
Arm chair racerFirst time rider
Well....it's the countershaft in your tranny, so you have to remove engine,split cases, take all the gears out ,and THEN.... put everything back together. It will be a good chance to inspect everything anyway....and to clean the oil filter rotor. You really should have a manual for this.
Power User
Got the holeshot
you have to deal with that sprocket soon.dont button her up with that turd on her.
1985 ATC 250R.Team Red Trike
Reply With Quote