New Here and Need Help Finding Fenders

[BLAZERONE22]

Here's my 200s It has a 1 piece fender.

[kdagenais]

Hello,
Looks like that is a 200M! Does it have electric start? I am just guessing here I would suggest you take the Vin numbers and as your local dealer to be sure wht you have before you start spending money.

[kickrz]

It says 1983 ATC 200 right on the serial plate.
It is pull start and the guy I bought it off of use to be a honda dealer and this bike was bought off his lot brand new.
So I would assume he would know that it is a plain 200.

[kdagenais]

Hello,
Just a few more questions to help identify. Are you sure it does not have an electric start along with the pull start? Cause by your picture it looks like it has an starter in the front where the 200M starter was located. Also can you tell which direction do you have to shift the transmission (Down or Up) to go through the gears from 1st-5th? If you have to push down on the gear shifter to shift through 1st-5th and pull up to down shift it probabaly is a 200 plain. Again to be sure what are the vin numbers (serial #'s) and somebody here could probably find out exactly what trike you have.

[Howdy]

It says 1983 ATC 200 right on the serial plate.
It is pull start and the guy I bought it off of use to be a honda dealer and this bike was bought off his lot brand new.
So I would assume he would know that it is a plain 200.

I am with you there. Honda did make a ATC200 There is no e, es, m, s, x letter.
Here is a 1983 brochure picture: http://www.3wheelerworld.com/Sads/sHonda1983atc200atc185sA.jpg

Notice there is no letters after atc200.


Mint Fenders are harder to come by. Maier doesn't make any and Honda discontinued them. Check you PM.

Thanks
Howdy

[kickrz]

Ok just talked to Honda to verify and yes it is a plain old 200 no letters to follow.
Positive there is no electric start, the fenders are 2 piece and I have to shift down.
So am I safe to assume no one makes aftermarket fenders for this bike??
Will any other model fit this 200 plain....

Thanks for the help so far!

[kdagenais]

Congrats on the mystery! Now to find fenders I am not sure what will swap but I am pertty sure the 200M has split rear fenders also so you might give that a try. I also would recommend contacting Jacks Cycle Salvage (http://www.jackscyclesalvage.com/) as I mentioned previously. As I said in previous post they seem to have a lot of ATC stuff but can get a little expensive. Ebay is another good source for this type of stuff but you need a little patience sometimes.
Good Luck!