spark plug wire

[wopa20]

This may be a stupid question but here it goes... I have a 200s and the boot is messed up. I want to change the wire but do not understand how it connects to the coil. after unscrewing the cap do i just pull the wire straight out? So the new one cut to length and push it in? This is all new to me. Lastly I found two types of plug wire one snap on one screw on which do you suggest? Thanks

[oldtoys72]

take the boot off, push and twist cable into new boot! Super simple, not a dumb question! I myself was used to the old style boot and had to be told how to work the new ones awhile back!

[_perroenegro_]

This may be a stupid question but here it goes... I have a 200s and the boot is messed up. I want to change the wire but do not understand how it connects to the coil. after unscrewing the cap do i just pull the wire straight out? So the new one cut to length and push it in? This is all new to me. Lastly I found two types of plug wire one snap on one screw on which do you suggest? Thanks

screw the cable to the boot and just push it to the coil, if you want, you could peel a little plastic from the tip of the cable, for better contact to the coil.

[bigworm626]

Yes, all of the above!

[wopa20]

Ok, I think that I did this properly...