New to the board
Arm chair racerNew to the board
Have any of you guys tried swapping a raptor or yfz450 rear end with the Z cause it looks like it will fit???
Also has anyone tryed swapping the yfz450 pegs cause there bolt pattern is looking the same to??
pics anyone???
I was looking into trying my curiousity.
At The Back Of The Pack
Arm chair racerAt the back of the pack
I think I remember it being done on a top tier build or maybe in the mad scientists section? not sure though would be nice I wonder if there is any + length to the yfz swinger.
Loves Corn.
Catch me if you can
Banshee looks like it will work also,,, BUT .. it dont! and the pegs I think were the right bolt pattern.. but the peg itself was rotated forward.. the bolt holes on a Z are kinda on a angle,, the YFZ are level.. pretty shure the people that used them ,, re-welded the the peg and Bracket
New to the board
Arm chair racerNew to the board
Thanks RAFFA, man your everywhere on here just about every post BAMM your there haha, yea thats what I'm thinkin Rijid Will a +2 and aluminium at that!! thanks dude's.
anyone else with more info???
RIDE's:
'86 Tecate (Stock, needs a right shroud )
'86 Atc 250r ( stock motor, fmf p/s, lonestar axle )
'85 Tri-z (bored , port/pol ,full DG ,38mik flat-slide, Shaw shock )
'85 350x (basket case) Sold
'84 Tecate ( +2 red westcoast swinger )
'82 Atc 110
'88 Tecate 4 ( stock w/ Fresh wiseco piston )
'86 Lt 250r ( Fmf p/s, 34mikuni flatS, +2+1 a-arms, +2 axle, +2 cal-fab swinger )
WHEN IN DOUBT.....THROTTLE OUT!!!
Reply With Quote