Just Too Addicted
Arm chair racerJust too addicted
the clymer manual calls for honda tool 07733-0010000. so i looked around flea bay and found flywheel pullers for 185s/200e,es,m. those pullers should work for the 200x or not? so do i have to use the puller or can i just use a bolt with the same threads to do the job?
Team Blue: 85 Tri-z 250: under the knife
Team Red: 87 Trx250r 01Cr80 15 CBR600RR
Team Yellow: 06 Ltr450 11 Hayabusa
Roostin' Away
Arm chair racerRoostin Away
If your talking about the flywheel the front axle will work. Same threads as the flywheel puller.
YTM-200, Wheeling machine!!!
1985 Honda 200x...
...Just a simple mild 200x
New to the board
Arm chair racerNew to the board
I have the tool you are talking about...It is like a long bolt with a t-handle. I bet a bolt of the same diameter & thread pitch would do the trick.
Power User
Lord of the trike
It's not actually a puller but a bolt that threads into the flywheel and pushes it off the end of the crank. It's a metric bolt, 14mm x 1.5 pitch. You might be able to get one from your local hardware store.
An impact wrench will zip it right off, or you can use an oil filter strap wrench to hold the flywheel while you turn the bolt clockwise.
Rob
Just Too Addicted
Arm chair racerJust too addicted
thx, that exactly what i was looking for. good pic rob
Team Blue: 85 Tri-z 250: under the knife
Team Red: 87 Trx250r 01Cr80 15 CBR600RR
Team Yellow: 06 Ltr450 11 Hayabusa
Reply With Quote
