Will a 200x wheel/tire work on the front of a 250SX?

[dougspcs]

I really want to switch out the front wheel on my 250SX with something a little slimmer profile and bit taller.

Will the front wheel from a 200x fit the front of a 250SX..I know they are both 4/110 bolt pattern.

Anyone that has tried this I would appreciate your feedback. How does it affect handling & ride?

I was thinking about picking this up..

http://cgi.ebay.com/ebaymotors/83-84...Q5fAccessories

[atc500x]

No.The 200x rear wheel bolt pattern is the same as the front and rear 250sx,but not the same as the front.The only way to fit this wheel is a adaptor plate.
All 250sx with this setup use a complete 200x or 350x complete front end

[dougspcs]

Thanks for the quick response 'atc500x' and bummer!!

I was really hoping to peal those small 'girlie' wheels/tires off the SX...

Are there any good replacement kits to 'man it up' and bit?

[atc350xer]

Thanks for the quick response 'atc500x' and bummer!!

I was really hoping to peal those small 'girlie' wheels/tires off the SX...

Are there any good replacement kits to 'man it up' and bit?

You can put a 200x front end on your sx.. lots of guys have done it... you'll need to make new steering stops though.

[dougspcs]

We'll see..I still have the NEW engine I found on craigslist to install. I found it at a machine shop in Michigan that handled the destructions when they were banned in the late 80s.

Zero hours..looking forward to hear it run.