i have a 82 250r and the thing will idel for days and will rev when sitting but when i try to go the whole thing like dies. i dont know and i am so pissed. it was just rebuilt with a 60 over wiseco. and i just put a new plug in it also. Please Help ME
At The Back Of The Pack
Arm chair racerFirst time rider
How experenced are you with two strokes? I know just a few months ago I started driving two strokes, and man I was frustrated. But after a while I learned you have to gun it quite alot more so that you dont dog it down.
But if you know all that good stuff, it could possibly be one of your jets, mainly the one that affects 1/4 to half. Which I think is the idle jet. But like you say it idles fine so I am not sure what you can do to help, unless what I said first works.
<center><B>1)</B>1983 250r <B>2)</B>1984 200s <B>3)</B>1982 185s Rebuild Project.
.:: Building 86 250r or cr500r or cr250r or ... sigh ::.
.::Visit www.MidWestTrikers.com trikes! ::.</center>
New to the board
Arm chair racerNew to the board
from my experienc with 2 strokes they tend to load up when idleing for long periods of time. also you might be running it a little on the rich side, cause even tho it will idle when you go to take off it already has fuel built up in the crant and the fuel coming and it gets flooded. thats just a guess tho without hearing the bike run.
86 200x all original exept fo pipe and filter
Power User
Teaching quads a lesson
change the plug. that is a great starting point
Thanks for all your help. What the problem was that the main jet in the carb was cloged and after i cleaned it out it ran like a charm. THanks again.
Power User
Teaching quads a lesson
.... Those aircooled "R" motors would rather run than not ..... I knew it was something simple.
J. Jonny D, --- Quad - Trike relations committee Chairman and all around swell guy.
Rides: '91 Warrior, '87 TW200, 1984 YTM225DX, 1984 ATC125M, '71 CL350 Scrambler
Reply With Quote