ATC200M carb question

[buckslayer]

I've got an '84 200M that I cleaned the carb on last night. After I reinstalled it, the bowl wouldn't fill with fuel. I'm assuming either the needle is stuck or I sloshed some dirt over the petcock in the tank. Any suggestions.

My real question: Anyone know the stock setting on the pilot screw for this carb/bike?

The whole reason I cleaned the carb was because I'm constantly fouling plugs and I thought it was running rich. It doesn't use a drop of oil, but I suppose that could be the problem as well, but I doubt it. They foul real quick at slow speeds, so I think I'm rich on the pilot.

Anyways, thanks for any help.

[ejc042]

Did you take the carb apart..if so you may need to disassamble again and check the float. If the float sticks it can cut the fuel flow to the carb.
I believe it is similar to the 185 and i think that is two turns out.

[buckslayer]

Thanks for the info.

Just took the carb apart and found my stupid assembly mistake. Should work fine now.

Next question (I think I'll post it as a new topic as well): I've adjusted valves on these engines before, but never on one without a kick-start. So, where is the timing mark access cover with the ripcord/starter assembly being on the left case like it is?

[ejc042]

Should be on top right at the back of the pull start assy.