200x Carb Help runs worse

[panthers06232]

cleaned the carbs on my 200x tonight because it started hard now it starts up runs at an idle really righ no matter what i do i tried adjusting the idle crew does nothing hit the throttle wide open doesnt make it rev very much at all not sure what is going on any help appreciated i have no idea what i did wrong i have cleaned a ton of snowmobile carbs but this is my first try at a three wheeler sometimes i can get it to idle down then it wont rev up please help

[tri again]

I can only say this because I've done it a few time.

That piston can go into the carb 360 degrees of rotation
and only one place that's correct.

I bet if you just unscrew the cap and rotate that piston as you push/pull, it will DROP in when it's right.

There's an inclined ramp on one spot that the idle screw kinda pushes up on.
and that's your reference.

I've also popped the 'w' clip that holds the needle down INside the piston.

Then the main needle is free floating and settles wherever it wants.

Or something is mounted crooked and you have a vacuum leak.
Did your 'o' ring happen to fall off?

pls keep us posted.
Sounds like a pretty common prob with ez answers.

[panthers06232]

i will tear it back apart i remember putting the cap back on and it slid down in thee just like the snowmobile arbs do is there more than one spot it can slide into

[250rRoostmaster]

Re-check your work bud, sounds like something is either still dirty or not assembled correctly..