First Time Rider
Arm chair racerNew to the board
OK so I took my hub apart to replace bearings and have it repainted. got it back awhile ago but I have no idea where the heck I put the axle collar.
do I need this part?
can I just make my own out of some tubing if I need to?
does anyone have one?
can't find one on eBay or anything which is surprising
thanks for any help
Formerly known as 84t3
Roostin Away
Yes you need this part. I am having the same problem but it is probably in one of my boxes of parts from dissasembly. If you find them somewhere, make sure to post where at.
Just sit back and chillaxx
Got The Holeshot
Arm chair racerJust too addicted
You could make one if need be. the ID needs to fit over the axle and the length needs to fit exactly between the inner bearing races. You should be able to measure the shoulder to shoulder dimension that's inside the hub in which the bearings seat up against to get the proper dimension for length.
Ross
My Rides
1985 250R original (Garage Queen)
-under restoration
1985 250R black and blue full rebuild ( Daily Rider)
-Paul Turner pipe
-+2" Westcoast
1985 Red and White Tecat-EH Sold
1985 Green Tecate Sold
My Wife's Ride
-2003 Suzuki LTZ 400 Showroom fresh and completely stock
My Kids Ride
-2004 Yamaha Blaster, Completely Stock
-2006 Yamaha Blaster, Completely Stock
Just Too Addicted
Arm chair racerJust too addicted
Yes, the collar keeps the bearings from side-loading. Without it, they'll probably last one ride, if that.
First Time Rider
Arm chair racerNew to the board
yeehaw i found mine! dad left it in his truck. time to get back to finishing this sucker up.
"The best way to tell if it's a Honda is to open it up."
At The Back Of The Pack
Arm chair racerFirst time rider
Before you install it, I'd measure it, if I were you, and stash the measurements somewhere safe. Just in case you ever lose it again, you could make one.
First Time Rider
Arm chair racerNew to the board
good call. I'm on 3-11 today. pas dropping it off at the house though. was gonna put it together tonight. ill get some measurements though n maybe make a bunch n throw em on the 3ww shop site.
First Time Rider
Arm chair racerNew to the board
my bad...I got all excited n put my collar and bearings and seals in this morning. then got to work n was like ohhh SH!+ I forgot to take measurements. I may buy a hub that still has bearings in it n take it apart though so I have another one n can make some up from that one
Reply With Quote