How to properly break a tri-z

[MTS]

Ran HARD!!!! alll weekend...no major problems. just ALOT of muskeg and water stuffed in it!

[WIkid500]

Good to hear it runs! . The only thing I broke this weekend was the gas blender Went from about 10,000 rpm's to zero like right now. Thankfully I have a spare motor, too early in the summer to kill the party.

[Dirtcrasher]

Hope you do well.

I absolutely beat the snot out of my Red Trikes and they never let me down. (knock on wood).

[Matrix]

I usually say a few smart ass remarks to people who do stuff like this but that is only because those people cannot repair their bikes like they should be, you can and i'm glad to see that. If we weren't so far away I would ride with you, sounds like a lot of fun. Good luck with el camexicans niece

[MTS]

my buddy got some decent gopro footage..of the ride need to get my hands on it. I ended up putting a allballs pivot kit in, wow what a differnce,my own mistake from the get go...the old bushings where worn baad! much tighter fit now. some new motor mounts, intake and a slight crank adjustment, pulled my ignition time back a bit and starts real well and pulls very hard...heck even the new pipe worked well..no leakes...