Any stuff to fix holes in plastics?

[74sickness]

I managed to put a hole into my plastic and im wondering if there is anything i can patch it up with and what paint would i use? Thanks

[remsandpets]

There are plasic welding rods that you can heat up and fill holes. Paint I'm not sure of.

[74sickness]

I will try that thanks a lot

[Tom'85350&70]

Where do you get them?

[atcman12]

use those rods buy them off a internet site most likely for auto body shops like my dad ive seen them before snd then i would put some bondo on it and sand her down only in that spot and see if you can paint her with an oil based paint that wont chip

[remsandpets]

Might try giving a welding supply company a call. Some can be done with low temp like a heat gun, others take a higher air temp to melt. I don't remember using flame just very hot air.