Power User
Roostin Away
Okay a lot of questions.Who actually still makes handle bars for a 350x?Besides the repop bars on eBay.Looking for something for track use.Something that is made for a trike.That lines up with the clamps.Looking for a new cutch lever set up also.One with a hot start lever.What front brake master cylinder will work?I have braided lines coming.
Power User
Roostin Away
For the handlebars, I have heard good things aout the renthal desert bend bars, they are very good quality, and a clamp on cross member, much better than the one piece bars. Here is a link for reference on ebay: http://www.ebay.com/itm/Renthal-Hand...item51a91e2371 As for the clutch lever, I have always used the parts unlimited shorty lever on ALL of my machines. They are only $12, so you can buy a few in case you tip it over on its side and break one. I know they are not a hot start lever, but does it really make that much of a difference? For the front brake master, any will work. I would think the newer the better. You could look for one off a dirtbike, or a Trx 400ex or 450r for starters.
THE 80's RAGE! Currently owns:
81, 85 Yamaha Tri Moto 125
83 Yamaha Tri Moto 200 x2
82,83 Yamaha Tri Moto 175 project
85 Yamaha Tri Z 250
84 Kawasaki Tecate 250
84 Honda ATC 70
85 Honda ATC 350X
84 Honda ATC 250R
(2) 84 Honda ATC 200x
82, 83 Honda ATC 185s
81 ATC 200
Lots of other parts and bikes
Power User
Roostin Away
FCR carb installed.
Power User
Roostin Away
Any other ideas on this question?
Power User
Catch me if you can
I Like the adapters for a fat Pro Tapers ATV bend. They are higher and strong. I have a ASV clutch lever and a master from a YZF 450 that Jeff (honda250sx) etched the top for me. I'm sure I can get a ASV for that also; Nice insurance!
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
Power User
Roostin Away
Only thing with raising will stock cables be long enough?Next is will the bars be straight until they are beyond clamps?Plus new throttle?Are the 450 bars 1 1/8"?
Last edited by jays375; 03-24-2013 at 02:17 PM.
weee weeee weeeeeeeeeee ! ! !
The day begins with 3WW
i have a set of low bend easton bars with adaptors . they are 1 1/8 .. pm if interested..
Power User
Catch me if you can
Hell ya, thats why I couldn't run Moose or Parts Unlimited do to the bend.Originally Posted by jays375
Yes, I believe they are 1.125 thick versus .875.
ATV or CR250 are what I used on a few machines.
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
Reply With Quote