Page 3 of 3 FirstFirst 1 2 3
Results 31 to 33 of 33

Thread: How far off can sprockets be

  1. 07-23-2013, 04:26 PM #31
    Kfx-xc-racer88's Avatar
    Kfx-xc-racer88
    Kfx-xc-racer88 is offline Just Too Addicted Arm chair racerJust too addicted
    Join Date
    Oct 2010
    Location
    South Wales, U.K.
    --
    525
    You could cut that section of the frame out and weld in a curved section for clearance.
    If it ain't sideways......what's the point!!



    86' Honda Atc 250R - under restoration
    10' Polaris Outlaw 525s - my XC race quad
    05' ATK 640 "Cannondale" xc racer
    00' Banshee 350
    Reply With Quote Reply With Quote
  2. 07-24-2013, 12:18 AM #32
    insanecreations's Avatar
    insanecreations
    insanecreations is offline First Time Rider Arm chair racerNew to the board
    Join Date
    Jul 2011
    Location
    Hickman, ky
    --
    70
    I guess I will have to.... I wish the all mighty derrick Adams would shine some light lol
    Reply With Quote Reply With Quote
  3. 07-28-2013, 07:05 PM #33
    insanecreations's Avatar
    insanecreations
    insanecreations is offline First Time Rider Arm chair racerNew to the board
    Join Date
    Jul 2011
    Location
    Hickman, ky
    --
    70
    Are there any weak points on the z frame I need to address before finial welding? Also what are some good rads that are short like z rads but thick?
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //