I bought new bearings from all balls racing there suppose to get ride of the lose ball bearings and i have most of it done but Im not sure what i need to Chang on the stem itself Any ideas?
First Time Rider
Arm chair racerNew to the board
I bought new bearings from all balls racing there suppose to get ride of the lose ball bearings and i have most of it done but Im not sure what i need to Chang on the stem itself Any ideas?
Power User
Got the holeshot
On the stem on the triples, make sure you pull the stock lower race and seal off.
Similar on the frame - knock the races out and replace with the races from the kit.
I took a picture during my 350X build because they drove me nuts on my 200X build.
http://www.3wheelerworld.com/showthr...97#post1112097
Last edited by jb2wheels; 07-20-2013 at 11:13 PM.
First Time Rider
Arm chair racerNew to the board
So after everything off does the seal just go on then the bearing?
First Time Rider
Arm chair racerNew to the board
Thank you i got it together
Reply With Quote