Results 1 to 2 of 2

Thread: porting and bore question

  1. 09-18-2013, 03:04 PM #1
    pounder76
    pounder76 is offline New to the board Arm chair racerNew to the board
    Join Date
    Sep 2013
    Location
    United States
    --
    25

    porting and bore question

    I want to get my cylinder bore honed and ported it's on it's first bore so I'm only going up one piston size but after it's ported will i have to get a bigger carb or just larger jets
    Reply With Quote Reply With Quote
  2. 09-18-2013, 03:15 PM #2
    curtis slawson's Avatar
    curtis slawson
    curtis slawson is offline At The Back Of The Pack Arm chair racerFirst time rider
    Join Date
    Jul 2009
    Location
    Canada,barrie,Ontairo
    --
    229
    Quote Originally Posted by pounder76 View Post
    I want to get my cylinder bore honed and ported it's on it's first bore so I'm only going up one piston size but after it's ported will i have to get a bigger carb or just larger jets
    You will have to jet it up rich . My 200x bored 20. Over with high compression and a huge porting job & DG full exhaust. stock jetted is 108main now i have a 120 main jet in it also might have to go higher on your pilot jet too i just went up one size on the pilot jet
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //