So I just got my top end back for my 400EX today
But the timing chain had fallen off the crank so I popped the clutch cover off to put it back.
And found this very NICE surprise
Question is: Will this clutch pack go in my 350X?
So I just got my top end back for my 400EX today
But the timing chain had fallen off the crank so I popped the clutch cover off to put it back.
And found this very NICE surprise
Question is: Will this clutch pack go in my 350X?
too many bikes to count. too little time on hand.
That's pertyyy!!!!! I hope somebody can answer this!!!!
There's one way to find out......
Well,,,,, if the 350 was at my house and I had a spare clutch cover gasket for it I would try. But as it is it's 5 miles away at my uncles house, and I don't have a spare clutch cover gasket. Plus, im not just gunna crack that thing open willy billy without parts. My luck I'll open it up and find the con rod sticking out through the crank shaft, tied in a knot around the clutch basket. It runs and rides and I'm gunna leave if that way until I know for a fact if this PE basket will go into it lmao
too many bikes to count. too little time on hand.
i don't think so the 300ex is the same as the 350x the 400ex is different
86 350x
85 125m
mint 87 250 citation
Thank you very much! I had read in a thread about one of the EX's being the same and the other different. But I couldn't find the feckin thread again no matter WHAT I searched!!!
too many bikes to count. too little time on hand.