At The Back Of The Pack
Arm chair racerAt the back of the pack
I tore apart an 86 200s bottom end I am using for an auto x project and I'm am looking for ways to clean the casings. The insides are good... just had some trash I had to clean out. But the outsides are filthy. I'm gonna scrub them, but is there something I can soak them in to eat all the grime and loose stuff off?
1984 Honda ATC 300r (Project Trike)
1981 Honda ATC 200 (Daily Rider/Hunting Trike)
Just Too Addicted
Arm chair racerJust too addicted
I use an engine grime remover from any automotive store. Works better if the motor is warm (not hot) let it soak, brush the really grimy areas then hose off. Pressure washer works good, just don't blast it on at full power too close...
My Trikes...
-1985 Big Red
-1986 250r
-1984 200x
-1980 110
-1980 ATC 185
Just Too Addicted: Protecting Our Community
The day begins with 3WW
engine degreaser, Simple Green, hot water, some scrubbing and maybe finish up with a wire brush on a drill or bench grinder?
Originally Posted by fabiodriven
Liberalism suspends the intellect of its victims, while at the same time tricking them into believing that they're smarter than everyone else.
If we've done business together, please leave me feedback. Thank You!:
http://www.3wheelerworld.com/showthr...t=Scootertrash
Reply With Quote
