atc 110 front axle help please

[freak trike]

hello someone can tell me or show (pic) the atc 110 front axle parts ...like the main shaft...the two long sleeve ...the two nuts an what else like i think i miss some special washer

[shortline10]

Yes 2 shoulder washers that catch onto the forks .
http://www.partzilla.com/parts/searc...EEL/parts.html

hello someone can tell me or show (pic) the atc 110 front axle parts ...like the main shaft...the two long sleeve ...the two nuts an what else like i think i miss some special washer

[freak trike]

discontinued ...it s ok i will make some new homemade whit a local shop .maybe i will make more than two if someone else want too

[freak trike]

if you can send me exact dimension diameter of hole.and shoulder....because mine is.not in good shape ...i have only one

[freak trike]

if you can send me exact dimension diameter of hole.and shoulder....because mine is.not in good shape ...i have only one its like 15/32 and 21/32

[shortline10]

Measure the hole in the fork and give it a little play , the outer dimension at the nut isn't all that crucial.

if you can send me exact dimension diameter of hole.and shoulder....because mine is.not in good shape ...i have only one its like 15/32 and 21/32

[freak trike]

ok thanks. that have too much play ....new will be more thight

[ps2fixer]

$10 shipped if you want em, look to be in good shape. Came off an 1982 atc110. I have other parts if you're looking for anything else (also have a 79 being parted out).

[freak trike]

i stay in east cost canada ...quebec...still 10 free shipping ?.

[ps2fixer]

Grr why does that boarder line have to cost so much to go past lol. Looks like shipping for 6oz is around.... $8, so $15 sound fair?

[freak trike]

lol border line ...for me is just a line on a map . thanks very much to try help me but i will go local macine shop ..for 20 i will have like 6 or 8 new piece

[freak trike]

i want to be an american ....lol

[ps2fixer]

Ahh ok, not a problem. I thought machine work like that was more expensive O.o. Back when Honda sold them, they were like $7 each, just an FYI.

[freak trike]

you right machine shop are expensive...but i have a good friend can do that for less price.i can do it myself but a dont have the tool.but i know how.i was machinist

[Asymetric]

I could have a part like that set up in about 20 mins. Then the machine would carve one off the end of a bar every 30 seconds or so. A job like that shouldn't be too expensive unless you wanted stainless.