1986 yamaha 225dx....racks???

[mitchell1965]

Looking to get front and back racks for my yamaha will the yamaha 200e racks work also are there any others that might work.....thanks

[YamaBoss]

I have a 200e rear rack on mine. I had to make a little bracket to get it to work. I also have a front rack that I haven't put on yet, but it should work.

[mitchell1965]

Yama boss did you cut out the holes in the back fenders, and what type of bracket did you have to make to get it to work.....

[YamaBoss]

Yes I cut holes, and I'll get a picture in a hour or so.

[YamaBoss]

There is the holes I drilled and what the mounts look like from the



Those are the mounts themselves. I took two piece of square tubbing, welded a nut in the smaller tube, welded it to the frame. I'm not finished yet, I still have to clean it up and paint it. But it works good, very strong and gets the job done.



These are what I used for the bolts. I got those handle caps for 5 dollars and then a long enough bolt to fit.

Or the other option is get a 200e grab bar that has these mounts built in. I couldn't find one and was pressed for time last fall when I needed my rack so I just made these mounts. Hope this helps.

[Yamawheeler]

I have an extra set of racks of a ytm 200 ern.

[mitchell1965]

How much you want for them, are they in good shape

[Yamawheeler]

Yes they are a good pair. A little paint and look like brand new

[mitchell1965]

How much you want for them yamawheeler

[muthey]

the yamaha 200k has a rear rack setup that clamps onto the rear grab bar and down to the rear carrier. it doesn't require cutting your fenders or any special mounting brackets