Dented expansion chamber...

[Jmoozy27]

.
POST EDIT BECAUSE I STILL HAVE NO EDIT BUTTON

oh...and i use a hammar with a bronze tip because it has a higher modulus of elasticity than delrin....plus they use it for landing gear bushings for 747'S

No bronze for me, too expensive... And I hate flying, it's way too stressful... Unless of course they let me drive. Then I would consider it.

[Jmoozy27]

Jason, you didn't happen to get the stock pipe on that deal did you?

Negative, on the stock pipe. I did t ask a lot of questions on that deal. Unfamiliar territory, dead end country road, pit bulls on chains, and only 6 shells in my revolver. As soon as the bike was in the truck, I was on my way out.

[coolpool]

I'm sure some will cringe but I've seen dents fixed with good old water. Fill the pipe area with water and freeze it. The expanding ice will push some dents out. I know it's not scientific and could split in other places if you put too much water in but keep a careful eye on it that will work to some degree.