200x front brake rotor install

[yaegerb]

Good point. Thanks.

Sent from my SAMSUNG-SM-G900A using Tapatalk

If you don't want to mess with it or can't get that bolt out, send it up to me with this kit and pay shipping both ways and we'll call it even Steven.

http://m.ebay.com/itm/1983-1987-Hond...995?nav=SEARCH

[redemn93]

Thanks for the offer. I should be able to handle it though. Feel kinda dumb for not realizing that before.

Sent from my SAMSUNG-SM-G900A using Tapatalk

[YTZ drew]

I've had a few that I couldn't get free. It's a real pain to set up in a press. I finally gave up on mine and put a kx80 rear caliper on my stock 200x bracket. It's a bolt on. I bought the whole kx rear brake setup for $25 shipped, and then used the master and line to freshen up my rear brakes.

[redemn93]

That was going to be my next option but here's where I'm at now. The pin is reluctantly moving but bracket is hitting the caliper body body. I'm almost there. Gotta figure this out now.




Sent from my SAMSUNG-SM-G900A using Tapatalk

[redemn93]

That was going to be my next option but here's where I'm at now. The pin is reluctantly moving but bracket is hitting the caliper body body. I'm almost there. Gotta figure this out now.




Sent from my SAMSUNG-SM-G900A using Tapatalk

Sent from my SAMSUNG-SM-G900A using Tapatalk

[ironchop]

I think I had to unscrew that pin to get the caliper off the bracket but don't recall.

Maybe unscrew the smaller pin. It has a hex base. Then you could swing the caliper up enough to get it to quit hanging on the bracket

Sent from my Z998 using Tapatalk

[redemn93]

Yeah. Pins stuck. Going to try and grab it with small channel locks.

Sent from my SAMSUNG-SM-G900A using Tapatalk

[redemn93]

Small pin is out. Tried swinging out. No clearance. Already destroyed the big pin. I may just cut it and find a new pin.

Sent from my SAMSUNG-SM-G900A using Tapatalk

[redemn93]

ended up getting a KX80 caliper. all bolted up and working last week. should've done it sooner. thanks for the help guys.