Tri moto 125 need carb help!

[gcoxon2000]

I have a Yamaha tri moto 1982 125 and i have taken the carb apart about 3 times i have cleaned it and blowen compressed air through every hole i can see i have made sure theres nothing plugged but it just wont run.. i have spark and if i spray gas right through the carb and into the cylinder it will run then rev really high (witch i know means its just leaning out from lack of fuel) and then dies nothing i do to this carb seems to make it work can anyone help me?

Sent from my SM-G925W8 using Tapatalk

[125Mmadness]

Maybe the float is stuck shut and not letting fuel into the carb

[gcoxon2000]

Where are you mix screws set and can you shoot carb cleaner through the pilot jet and see it come out of the circuit on the other side

Yes i can shoot carb cleaner through the pilot jet and see it come through and the idle mix screw is set at 1 and a half turns out (thats what the manual says to have it at)

Sent from my SM-G925W8 using Tapatalk

[gcoxon2000]

How do i see if there is gas in the bowl?

Sent from my SM-G925W8 using Tapatalk

[gcoxon2000]

Okay then it does have gas filling the bowl because it spills everywhere when i take it apart

Sent from my SM-G925W8 using Tapatalk

[Rob Canadian]

I don't know much about your trike. But supply more details.

Did you just get it? Did this all of a sudden happen? Yes it sounds like a fuel issue for sure. Or to the best of my knowledge.

[gcoxon2000]

I don't know much about your trike. But supply more details.

Did you just get it? Did this all of a sudden happen? Yes it sounds like a fuel issue for sure. Or to the best of my knowledge.

I just got it a week or so ago and when i got it. it didnt run also the fuel cock thing lets fuel come from the tank and i put a new feul line on it aswell the only thing i dont have hooked up to it is the exhaust and the air box and i dont have and air filter could that have something to do with it?

Sent from my SM-G925W8 using Tapatalk