Got The Holeshot
Arm chair racerJust too addicted
I can't find the two gaskets needed to assemble a 200es sub transmission.
Will deleting them and just using a quality forma gasket or high temp rtv throw the gears out of whack? The thickness of the gaskets are part of the spacing. I would hate to assemble things only to have the thrust washers too right from the case closing in tighter
Anyone know where to get the right gaskets?
Thank you.
I was born and raised on Venus & I may be here a while.....
Power User
The day begins with 3WW
You try looking for OEM?
Nvmnd....im sure you did.
I just went and looked too and I see they are discontinued
Sent from my Z958 using Tapatalk
Last edited by ironchop; 08-24-2018 at 07:03 PM.
Putting Priorities in Order, Busier than ever.
Catch me if you can
If you have a Cereal or such box you can make a gasket and it's very close to the oem thickness. Been there done it many times when gaskets can't be found. I find they hold up very good as well.
Howdy
Reply With Quote