First Time Rider
Arm chair racerNew to the board
Bought this 86 250R atc motor awhile back and just had some time today to finally have a look at it, well, I found out why it's not holding any air on a leak down test. It has a pretty big hole in the center of the cases behind the counter balancer area. Anyone think jb weld would seal this up if it was done properly? I've had some success with jb weld over the years, but didn't know if this would be going to far. Any other thoughts? Thanks.
yaegerb
The day begins with 3WW
Get it professionally weldedOriginally Posted by rmcollector
Bought this 86 250R atc motor awhile back and just had some time today to finally have a look at it, well, I found out why it's not holding any air on a leak down test. It has a pretty big hole in the center of the cases behind the counter balancer area. Anyone think jb weld would seal this up if it was done properly? I've had some success with jb weld over the years, but didn't know if this would be going to far. Any other thoughts? Thanks.
Just Too Addicted
Arm chair racerJust too addicted
^^what he said. There's a feller named Dave Moore out of Texas that I've sent 2 sets of cases to in the past. He is one of the best in the business at repairing 250R cases...he can practically fix any broken or damaged case out there.
Reply With Quote