I finally did it and bought a three wheeler. About a 1984 Honda big red 200 ES that needs help.

I believe you would call it a basket case. It had been sitting in a barn for three years left in a state of it would not start since it sat so long the motor had seized. I filled the top end with diesel fuel and Marvel mystery oil and let it sit for a week gently pulling the pull start every now and then till it came free. I have since drained the oil put all fresh new oil in there. I’m looking for some key parts, best places to start , and trying to figure out the best place to start in this large form.

I need a CDI, which is missing it came with a CDI for a 250 Big Red
I need a choke cable
I need what I believe is the reverse solenoid or fuse
I have a coil and spark plug wire on the way
The bike came at the new carburetor
All the plastics some broken
The normal bad front shock
And I have the bike soaking in 50 cans of WD-40🤣

If I put the bike in higher or low, everything spins freely, nothing‘s bound up, but I cannot get it out of gear

I do have previous experience doing this. I rebuilt a 97 warrior during the pandemic that was about in the same place, but finding parts for this three wheeler is a bit hard.