I’m a little rusty when it comes to working on these so forgive me if I’m asking way too many questions. But anyhow I recently acquired a 200, it’s a basic machine with a pull start. The plastic is in great shape and the frame has little to no rust. I’m wrestling with the pull start as of now, then I noticed when I rocked the machine side to side that the chain side axle bearing has some play. So I’ll be tackling that after I get it running. I’m pretty sure the carb is going to need cleaned at the very least. The previous owner said it ran, but only for a minute then died, then he broke the rope and tried to rebuild it… that’s where I’m at with this so far.