Still active?

[pantodd74]

Been some years since logging in. Is this place still active? E2S is pretty much dead. Formerly known as FPMXer here some years ago.

[Red Rider]

Much less traffic here these days, but yes, still active.

[AMSinator]

Definitely low activity on site, as I'm presently the only one browsing this thread @ 9AM EST.

AMSinator
https://www.amsoil.com/?zo=352885

[J!m]

I’m the new guy and disappointed with the lack of traffic.

But I am finding lots of good info searching the rusty shelves and made a couple friends along the way.

[AMSinator]

I did notice 38 members/guests viewing the site yesterday evening @6pm EST.
I was the only member @ that time.
Same here, been actually adding info/content to old threads relevant to thread, hoping to spark life.

What-cha' searchin'?

I've been researching the Mikuni Flat slide TM28 Curtis Sparks (IIRC) kit sold for '83-'86 ATC200x.
Bought 2nd hand still in box, way back in '88 or so.
Came w/ quick turn twist throttle setup.

Used it on my Powroll 218cc engine in 1st Gen '81 XR200R MX/Woods racer
Later put engine in 2nd Gen '85 XR200R full cradle frame.
Flat slide TM28 interfered w/ frame backbone, so had to go back to round slide Mikuni VM28 originally started with.
Looking to put back in service, so trying to verify parts for emulsion tube, jets etc.

AMSinator
https://www.amsoil.com/?zo=352885

[shortline10]

The 28mm mikuni flat slide works fine with the correct manifold and a little massaging to the carb and frame .
You will find the mikuni round slide makes better low end power and the flat slide performs better in the higher rpms .

[Tompkinsj24]

I love my 3wheeler. I log in here rarely but i hate the lack of people keeping them on the trails. But parts can be a pain to find.

[scrambler_92]

Newbie to forum but lurker for some time