Registered User
New to the board
ok i have this klt200 and everything is ready to go except the wiring. i hate wiring so im no good with it, and dont know much about it.
so my question is....if i want to get spark, JUST SPARK, what are the essentials i need? there is no wiring structure even set up on this 3 wheeler. so im starting from scratch. I dont want any headlights or switches or any fancy stuff, i just solely want to know the bare essentials for getting spark. Any help is really appreciated! thanks
Power User
Roostin Away
were in the same boat my wirings gone too the bad news is that its got CDI so you have to go through doing the most of the other wiring.
IM looking for a CDI wiring diagram for one of these too
Hoarder of the finest junk
'82 YT175
'83 YTM200
'85 KLT110
'86 Moto 4 225
'84 TRX200 trike conversion.
'87 Tecate 4
Lots of vintage and not so vintage two wheeled stuff.
Registered User
New to the board
i have a wiring diaram for a 1981 klt200, but it is different, if u want i can scan it and send it to you, it might be some help.
Power User
Roostin Away
i already have the whole service manual but it has the diagram for points. i think mine is a later motor in an 81 frame
Hoarder of the finest junk
'82 YT175
'83 YTM200
'85 KLT110
'86 Moto 4 225
'84 TRX200 trike conversion.
'87 Tecate 4
Lots of vintage and not so vintage two wheeled stuff.
Registered User
New to the board
sorry, im sort of new to this, i dont understand what u mean by "points". can u please help me out here? thanks.
Reply With Quote