New to the board
Arm chair racerNew to the board
and decided to disassemble my 86 350X. Being that I have no experience in doing this, what should I be careful of???? Are there cetain things that need to be checked while I'm down to engine and frame???? I will be attempting to put new Barnett fiber and steel clutch plates in it sometime next week. Any advice on what I should do would be greatly appreciated because I am just wrenching in the dark.
Thanks
Ted
1986 350X
1984 125M
1977 RM80
1982/72 ATC Elsinore/250R
New to the board
Arm chair racerNew to the board
so.... any advice would be welcome... .... ... .... ....
1986 350X
1984 125M
1977 RM80
1982/72 ATC Elsinore/250R
Got The Holeshot
Arm chair racerJust too addicted
Not sure about the steel plates but the fiber ones need to be soaked in oil over night or they will be slipping in no time. I learned this the hard way.
86Honda250R
85Honda250R Sold
82Honda250R
Tiger 200 198? Sold
Tiger 250 198?
Tiger 80 (need engine) Sold
85 Tri-Z
86 Tecate
Perfection consists not in doing extraordinary things, but in doing ordinary things extraordinarily well.
At The Back Of The Pack
Arm chair racerFirst time rider
the best advise i can give you is go to the honda dealer and buy a 350X service manual. they are less than $40 and can save you much $$$.
Tim is the name
85 350X(86 motor)
83 200X(stripped down for a total rebuild)
85 200S(project)
Reply With Quote