Results 1 to 2 of 2

Thread: 200x piston/cylinder Q?

  1. 04-03-2004, 01:45 PM #1
    Yamaha_Rules69's Avatar
    Yamaha_Rules69
    Yamaha_Rules69 is offline Power User Roostin Away
    Join Date
    Jan 2003
    Location
    Southern MN
    --
    1,875

    200x piston/cylinder Q?

    Ok, I have a Weisco high compression piston and rings in a box full of 85' 200x parts I bought a while back. I had two stock cylinders, and what that I assumed was one bored out cylinder, because it has fresh cross-hatch lines. On the bottom of the cylinder someone wrote 2.561 in perminant marker. I used a micrometer on the piston, and it came out 2.557, which is only .004 inch diffrence. My question is is this the cylinder that should go with this piston?
    Also, if I put in a high compression piston and bored cylinder, would I have to buy a bigger carb or change the jets or exhaust? How do you know what ratio the piston is (ex. 10 to 1, 12 to 1)? Any help or advice on this would be greatly appreciated. Thanx again.
    THE 80's RAGE! Currently owns:
    81, 85 Yamaha Tri Moto 125
    83 Yamaha Tri Moto 200 x2
    82,83 Yamaha Tri Moto 175 project
    85 Yamaha Tri Z 250
    84 Kawasaki Tecate 250
    84 Honda ATC 70
    85 Honda ATC 350X
    84 Honda ATC 250R
    (2) 84 Honda ATC 200x
    82, 83 Honda ATC 185s
    81 ATC 200
    Lots of other parts and bikes
    Reply With Quote Reply With Quote
  2. 04-03-2004, 02:27 PM #2
    samster143
    samster143 is offline Just Too Addicted Arm chair racerJust too addicted
    Join Date
    May 2002
    --
    610
    My advice would be to take the piston and cylinder to a shop FAMILIAR with Wiseco pistons and have it measured by them and see what they say. I think .004" is about right for wiseco's but I am not real sure. Hope to have helped.
    Sam from Florida
    1985 BIGRED $ 200X
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //