Power User
Got the holeshot
Gday,
Pulled my head off today but the lower exaust stud bolt snapped off, leavign about a half centimetre left. I have had it in the vice trying to turn it but it will only give a small bit and then stop again. The top one was threaded and came out easily. Is this one pressed in or threaded also? How do i get the trailprotrailprotrailprotrailprotrailprotrailprotrailpro out?
Thanks,
Matt
1980 ATC 70 Needs Restoration
1985 ATC 250es Fully Refurbed
1986 ATC 350x Mint Original
Dirty Main jets are my bane.
4 Wheels? Huh?
i took my 350X ones to a machine shop i heard you could weld a nut on their
Power User
Got the holeshot
D/W i got it off at last.
Just needed a bit of heat and lubricant.
Matt
1980 ATC 70 Needs Restoration
1985 ATC 250es Fully Refurbed
1986 ATC 350x Mint Original
At The Back Of The Pack
Arm chair racerAt the back of the pack
It would be threaded on there. I run into this all the time. I just a little PB blaster lube and a low torch flame. If that doesn't work, use an easy-out screw extractor before you mess things up too much. If there is enough to weld a nut onto so you can back it out that way, go for that one too.
Anyone know of a new project machine for me around Wisconsin?
Reply With Quote