200s problem

[threewheelin-feelin]

well i got it running better today got it were i can adjust the idal think god. but its still fauling plugs it was really realy black .my uncle look in his book and said he think the exhaust valve isnt opening all the way. do yall think that could be the problem? its spittin fire real bad will die after about 15 mins let me know.

[jeswinehart]

sounds to me just a good ole going thru + tune up is in order. from aircleaner to timing and valve adjustments ( if needed ) ,,, + since it's been running rich ,,, don't forget to clean the exhaust pipe out.


john

[threewheelin-feelin]

well i know it need the valves adjusted its only running off 120psi of compression. should have 156 so we will go thu it and check every thing out.

[jeswinehart]

you might already have a manual but in case you don't i have a clyners manual i can get needed info from it for you.

good luck ,,, john

[threewheelin-feelin]

ok thinks buddy ill let u know if i need any

[MX125dude]

Well this is kinda off topic but how much horse power does a 1984 200s make?

[threewheelin-feelin]

i think 12

[MX125dude]

Wow thats really shocking, i hope its more, but since i took the silencer off of the tailpipe how much would that boost the horsepower

[83185s]

did u try adjusting the fuel/air mix screw twf?? my 185s did smae and all i had to do was turn it then set the idle right...and taking off the silencer and only having the header wont boost it much mx125...it gives it a little bit more torque but not much..i did it with mine ..but only cause it was rusted out..lol...im planning on getting a full cobra exhaust for it...hehehe...hope u get it runnin right twf

[83185s]

o yea...where u get the bassani pipe at??? i may get one of them instead

[threewheelin-feelin]

i dont know it was on it when i got it i think it was put on shortly after the bike was bought new maybe in like 86 or 87