Power User
Roostin Away
Over a year ago i pulled the motor on my 85 200x. long story short, i purchased a different bottom end and just had the cylinder bored and a valve job done. This was a year ago and i'm just getting around to putting it back together now. I see the bottom end I have doesn't have a cam chain in it. Do I to totally disassemble the bottom end in order to put a chain on it? I have the chain from my other bottom end, but I REALLY dont want to have to split the cases if I dont have to!
85 250SX New to me!!
85 ATC 70 stock ~ TRADED
85 ATC 70 with 138cc Lifan
83 110 restored ~ sold
85 110 restored ~ sold
83 200x restored ~ sold
02 400ex ~~~SOLD
K&N filter
K&N jet kit
EHS Racing lid
Removed choke 42 pilot DJ146 main
HMF full exhaust
AC skids
Holeshot XCR rears
14t front sprocket
IMS Roll front bumper
Graydon Proline nerfs
First Time Rider
Arm chair racerNew to the board
Its been a while since i have had one apart but i believe you can remove the rotor stator on the left side of the case to thread the chain on the lower sprocket. You will need a bolt puller to remove the rotor they are about 10 bucks.
Happy Trails
Power User
Roostin Away
a bolt puller? i can just thread an axle bolt in can't i?
85 250SX New to me!!
85 ATC 70 stock ~ TRADED
85 ATC 70 with 138cc Lifan
83 110 restored ~ sold
85 110 restored ~ sold
83 200x restored ~ sold
02 400ex ~~~SOLD
K&N filter
K&N jet kit
EHS Racing lid
Removed choke 42 pilot DJ146 main
HMF full exhaust
AC skids
Holeshot XCR rears
14t front sprocket
IMS Roll front bumper
Graydon Proline nerfs
Reply With Quote