New to the board
Arm chair racerNew to the board
86 Tri-Z ?'s & probs
I keep seeing it different on posts but I just want to make sure it is correct. But moving the needle and clip are the same on different carbs, right?
Moving the needle up while lowering the clip "Leans"?
Moving the needle down while raising clip "Riches"?
Also anyone have any idea where my stock carb off my 86 should the clip be in what position?
What plug should I run in my Z? B8ES or B9ES?
86 Yamaha Tri-Z
Enough mods but need more
So bombed at TF I needed both hands to hold my beer
Teaching quads a lesson
moving the clip UP on the needle leans it, moving the clip DOWN richens it.
most comes stock in the middle, although im not 100% sure on Z's
either plug will work, in NGK the lower the number the hotter the plug burns, the higher the number the cooler it burns (8 will burn hotter then 9)
Trikein' Away
Arm chair racer4 Wheels? Huh?
The stock plug for it is b8es and stock clip setting is the 3rd groove down, farther up is leaner and down is richer.
1985 YAMAHA TRI-Z 250 sold
2006 YFZ 450
New to the board
Arm chair racerNew to the board
Should I run the B9ES in it then, if stock is B8ES? I just want to make sure I don't screw it up.
86 Yamaha Tri-Z
Enough mods but need more
Trikein' Away
Arm chair racer4 Wheels? Huh?
you might foul plugs.
1985 YAMAHA TRI-Z 250 sold
2006 YFZ 450
Reply With Quote