Registered User
New to the board
I have a yamaha 200e 3wheeler with electric start. it won't run and my lights won't come on. the bulbs are good, before I charged the battery everything was fine then after installing the fully charged battery it won't start and none of my lights will come on, neutral,reverse, headlight etc. I have 12 volts at the switch but nothing anywhere else. any one have any ideas.?
Power User
Teaching quads a lesson
I know this sounds dumb but could happen, just check the connections on the battery and make sure you have positive on positive. Then I would trace from there following the wiring all the way up to the on/off switch. Also try starting it without the battery and see if there is any problem there.
86-87 Tecate ROCK!
Ride fast...........brake late............and Slide the rear!
Registered User
New to the board
thanks scottzj for your reply..Will check out your suggestions and post later.
At The Back Of The Pack
Arm chair racerAt the back of the pack
If you did cross the terminals, then you probobly blew a fuse some where.
Pull the plug from the block and ground it to the head, and pull the cord, or kick it what ever form of manual starting you have, and see if you have spark to the plug, then work your way back from there, the problem should become apparent eventually, but like i siad, it SHOULD become apparent, trouble shooting is the hardest part of repair.
If you can't fix it with a, its an electrical problem.
85 ATC 200s--Ratted out and not running at the moment
86 ATC 200x--All stock other than the handle bars
85 ATC 250es Big Red -- Just got new rubbers and she wants to ride!!
04 Suzuki LTZ250 quadsport - It was a decent price and I'm a raging idiot.
Registered User
New to the board
I have power at the switch and at the plug but it still acts as if its shut down. still no lights of any kind.
At The Back Of The Pack
Arm chair racerAt the back of the pack
Check to make sure that you didn't pull the plug off the neutral switch. They can also go bad, they wear down with time. The rest of the lights don't work off the battery, unless it is different than a 225 and it won't start off the electic unless the neutral indiator/switch is working properly or you ground the connector. If the plug in on the the neutral switch, pull it off, ground it and see if it comes to life.
Anyone know of a new project machine for me around Wisconsin?
Registered User
New to the board
Will try that next, olderfox....thanks
Registered User
New to the board
traced the ground back to the neutral switch and if I ground it right where the wire comes out then the light works but doesn't work without a seperate ground..so I can only assume that the switch is screwed or it is not going into neutral.
At The Back Of The Pack
Arm chair racerAt the back of the pack
chances are the switch is shot, it happens. i had to replace one of mine
Anyone know of a new project machine for me around Wisconsin?
New to the board
Arm chair racerNew to the board
does the 200E have reverse?
Power User
Got the holeshot
Originally Posted by 1983yamaha225
Nope, reverse comes on the 200es, and 250es
'85 350X-The Flagship
Speedo, Chrome HL Guard, Rubber Steps
DG Chrome Power, 6-Pack Rack, White Bros Skidplate, 400ex Carb
'85 250ES Big Red-Working in Style
Many Hondaline & Aftermarket Add-ons
'84 250R-Old School Racer Project
Too many Accessories to List
'82 200E Big Red-The Tractor
Rubber Steps, Tripmeter
'85 250SX-Rider
Various Accessories
'13 CBR250R & '05 CBR600F4i-Road Toys
Yoshi Slip-Ons & Fender Eliminators
At The Back Of The Pack
Arm chair racerAt the back of the pack
If it is a Yamaha it would be a YTM200ERN if it had reverse. There are 2 models of shaft drive 200's, one with reverse, one without
Anyone know of a new project machine for me around Wisconsin?
Reply With Quote