Power User
Lord of the trike
on an 82 . 200
How bad is that !!
Starts and runs like a champ tho... i started , ran it on idle for 5 minutes or so.. could have been warmed up a bit more. Gonna try it again after running around the yard some another night.
I find that if i run it on 1/2 choke it rev's up better than with no choke .. once fully warmed up it idles and runs without choke.. but with 1/2 choke.. it runs better !
Power User
The day begins with 3WW
heh you did do this with the decomp lever disconnected right? 90psi is really low......
1985 Tri-Z-
Originally Posted by mywifeknowseverything
Registered User
New to the board
I just tore down my top end and it was at 85psi on my 125. It woulnt even turn over.
97 RM 125<----Mine(too many parts to list)
03 CR 85<---Brothers
Soon to come 83 ATC 250r
Power User
Lord of the trike
It's got no decomp lever cable, however i did not check the arm position, but i beleive it's spring loaded to close.. gotta check that.
Just Too Addicted
Arm chair racerJust too addicted
Check the valve clearance. AS the valve seats wear in, the valve stem gets closer to the rocker arm, eventually preventing the valves from closing completely, thus causing a loss of compression.
Reply With Quote
