http://www.denniskirk.com/jsp/produc...Id=&leafCatId=
The offset says it is 3.5 + 5. Does this mean I could mount them either way and the one way would make my rear end wider????
At The Back Of The Pack
Arm chair racerAt the back of the pack
http://www.denniskirk.com/jsp/produc...Id=&leafCatId=
The offset says it is 3.5 + 5. Does this mean I could mount them either way and the one way would make my rear end wider????
1981 Honda ATC 185s
-DG Exhaust
-200x Carb
-Uni Filter
-Air filter box removed
-10T Front Sprocket
-Plastic fuel tank
-Aftermarket seat
-200s front forks/shocks
-Aftermarket 4 bolt rear wheels
-Tire chains when ice riding
1988 Ford Mustang LX 5.0L
-Wayyyy too much to list!!!
At The Back Of The Pack
Arm chair racerAt the back of the pack
I don't think they are intended to be used that way but you can. They probably have the valve stem on the 5" deep side to begin with, so if you flip them your valve stem will be on the inside and you will have a narrower rear end.
1985 Honda ATC 250 Big Red
"Ugly Betty" from the handlebars back it's a
1982 Honda ATC200es, from the handlebars
forward it's a 1988 Honda TRX 300 Fourtrax.
"If you wanna play, you gotta pay..."
At The Back Of The Pack
Arm chair racerAt the back of the pack
Makes sense.
1981 Honda ATC 185s
-DG Exhaust
-200x Carb
-Uni Filter
-Air filter box removed
-10T Front Sprocket
-Plastic fuel tank
-Aftermarket seat
-200s front forks/shocks
-Aftermarket 4 bolt rear wheels
-Tire chains when ice riding
1988 Ford Mustang LX 5.0L
-Wayyyy too much to list!!!
Reply With Quote