Results 1 to 7 of 7

Thread: 1976 ski-doo tnt ice-buildup

  1. #1
    Join Date
    Jul 2004
    Location
    minnesota
    --
    689

    1976 ski-doo tnt ice-buildup

    ok, on my ski tnt i have a terrible ice build up under the hood and it just will not stear at all, i went to ride it today i took off and i almost hit the my garage because i could not stear, anyone haveany tips for getting rid of the ice, ive tried the torch, ive tried a and a screwdriver and ive tried hitting it with my boots.
    my trikes:
    1983 honda atc 200x-k&n filter
    2002 yamaha raptor 660r, yoshimura slip on, prm grab bars
    1978 chevy nova, 454 v8, bds blower, 150hp shot of nitrous, full roll cage, a real power house.
    1991 chevy s10 4x4 350v8.
    1986 250sx
    YES its fast NO you cant ride it.

  2. #2
    84250r is offline Clean enough to eat a potpie off of Teaching quads a lesson
    Join Date
    Oct 2002
    Location
    Michigan
    --
    2,718
    Try hot water,but dont put it where the motor could suck it up.

    If a buddy has a heated garage I would put it in there for a couple of hours.
    R.I.P Raven

    2006 Yamaha Banshee Special Edition
    1996 Honda CBR 600 F3

  3. #3
    Join Date
    Sep 2004
    Location
    Brandon, Manitoba
    --
    2,209
    have you been riding in powder snow? i was having trouble with my sled freezing up before because too much snow got in the engine compartment through the vents. What i would do is what 84250r said and let it completly thaw out
    Then tape up the vents and take a razerblade and cut slits in the tape so the engine can still cool down. It works pretty good, there is no snow packed in my engine any more.
    I am going to take the tape off when there is less powder here becuase it looks goofy

  4. #4
    Join Date
    Jul 2004
    Location
    minnesota
    --
    689
    yes i do ride in alot of powder snow, and most of the time when i do ride it i go into big drifts and stuff, and this has never happened to me before, but i will try your idea of taping up the vents, and pourin hot water on the ice and snow and see if that works,thanx for the advice.
    my trikes:
    1983 honda atc 200x-k&n filter
    2002 yamaha raptor 660r, yoshimura slip on, prm grab bars
    1978 chevy nova, 454 v8, bds blower, 150hp shot of nitrous, full roll cage, a real power house.
    1991 chevy s10 4x4 350v8.
    1986 250sx
    YES its fast NO you cant ride it.

  5. #5
    Join Date
    Sep 2004
    Location
    Brandon, Manitoba
    --
    2,209
    If you do that, be very careful and make sure the heat can escape, i left the vents behind the windsheild wide open.
    good luck!

  6. #6
    Join Date
    Jul 2004
    Location
    Minniesota
    --
    115
    get hood screens

  7. #7
    Join Date
    Jul 2004
    Location
    minnesota
    --
    689
    hey hondawilly i have mesh hood screens and vents, but the snow got threw them,and thankx guys i didnt poor hot water inthere instead i just took the torch and meteld all the snow and ice from under the hood, and now it steers perfect, and then after that i ducttaped the front hood vents and cut slits in the tape and left the rear ones open.
    my trikes:
    1983 honda atc 200x-k&n filter
    2002 yamaha raptor 660r, yoshimura slip on, prm grab bars
    1978 chevy nova, 454 v8, bds blower, 150hp shot of nitrous, full roll cage, a real power house.
    1991 chevy s10 4x4 350v8.
    1986 250sx
    YES its fast NO you cant ride it.

//ArrowChat Integreation Code //