Registered User
Just too addicted
250r carb problems
i pulled out my 250r today and noticed the petcock was left at 'on'. i tore up and down the street once, but when i parked the bike, and turned it off, the carb was gushing fuel out of a hose on the bottom of the float housing. the drain hose continuously pours out gas. it only gushes fuel when i have the petcock on 'on'. is the float valve stuck? do i need to just clean the carb? what should i do?
Last edited by monster 84r; 07-12-2005 at 09:55 PM.
Registered User
Just too addicted
its harder to start now, and running a little rich if that helps, hope * guys can tell whats wrong
At The Back Of The Pack
Arm chair racerFirst time rider
sound like there is something holdin the needle off it seat. Pull the carb apart and check it out, also check your float level. And if you dont use an inline filter I would advise putting one in.
IN MY GARAGE:
1984 250r
1986 350x
1986 200x(wifes)
1985 200x fixer upper
1979 110 PARTING OUT
1984 70
http://www.hardcoresledder.com/forum...post&id=155447
'97 ZRT 600 drag sled
'97 ZRT 600 trail sled
'98 ZR 440 sno-pro(wifes)
http://www.hardcoresledder.com/forum...=post&id=79401
Registered User
Just too addicted
where could i find instructions on doing this? ive cleaned carbs before but i dont trust myself tearing into the ol' keihin. are there any articles that would help me out? thanks
Last edited by monster 84r; 07-12-2005 at 11:50 PM.
Reply With Quote