this bike does have a "rev limiter" correct?... is it possible to over rev it winding the gears out? or in nuetral or when missing a gear? i just thought i needed to know for sure..... usually a cdi does this but i just need to hear it
At The Back Of The Pack
Arm chair racerAt the back of the pack
this bike does have a "rev limiter" correct?... is it possible to over rev it winding the gears out? or in nuetral or when missing a gear? i just thought i needed to know for sure..... usually a cdi does this but i just need to hear it
Last edited by toyvette81; 07-25-2005 at 11:13 PM.
P3 Member ( RIP 8/15/2018 )
The day begins with 3WW
no rev limits to a stock 85 - 86 350x ,,, well till it blows that is.
9 grand is start of red line if i remember correctly.
john
At The Back Of The Pack
Arm chair racerAt the back of the pack
oh that sucks.... can i over do it by winding out the gears???
At The Back Of The Pack
Arm chair racerAt the back of the pack
see im asking b/c today i tested out my new 14 tooth front sprocket to see how much it affected the low and top end... i accidently( i guess) would out the gears a little more than normall, then i was paranoid about a noise in the motor) im like "is that a valve ticking?! bla bla bla etc... my dad said i was paranoid but it does sound a little different.. just the motor noise or mabye it was b/c it was hott. but my best explination of the noise is like a rotating wheel on ball bearings... no ticks. dings etc. just a rotating sound, im sure its just me and just the motor's noise... right!?
Power User
Lord of the trike
Timing chain old ?
Currently :
82 ATC - 200, plain jane, almost mint. ( Sold, 03-17-2005)
84 ATC - 200 ES, Jimmy-Rigged, don't ask.( Sold, 03-17-2005)
85 ATC - 250 SX, Pride and Joy, Bottom-Less Money Pit.
84 125 M - The Mini-SXnot running yet. but won't be long.
--
The more people i meet.. the more i like my DOG !
Got The Holeshot
Arm chair racerJust too addicted
I have run my 350X wide open on the hard pack at the beach for several miles at a strech. The motor winds up until it stops and stays there. No damage I can tell, still runs great
ATCnut
82 185s - sold
83 200x (hopped up)
84 200x (stock)
84 70 (lost this one to the DMV)
85 70 (soon to have lights, a foot brake, and CDI ignition)
84 200es (parts trike) - sold
85 350X (the best)
85 350X (siezed motor, dream of a poweroll kit someday)
85 250sx (frame was trash, got parted out)
86 250sx (the tractor)
86 250sx (a nicer tractor)
86 250sx (an even nicer tractor)
87 200x (parts trike, its really rough, a dog was chewing on it for a while)
87 250es Big Red (the tank!!)
Trikein' Away
Teaching quads a lesson
If your engine has overheated before reving it out can throw out your lower rod berring. I have a bad crank because of that. A ding isnt good. Your not going to hurt the engine by reving it out unless you float the valves, or overheat it.
Reply With Quote