New to the board
Arm chair racerNew to the board
I have a 84 honda 200m the pull roap is full of oil.Is there a seal there.The 3 wheeler runs great I start it with the electric start but when I pulled the roap oil came out.I loosened the cover and it was full of oil could some one tell me whats wrong.I just bought it and its in great shape.Do they make a front rack for this 3 wheeler factory.I have a rear rack but no front one or which one would fit and where do I buy one.Im new to this site and its awesome.
Got The Holeshot
Arm chair racerJust too addicted
Yes there is a seal - for the crankshaft in that area- Do you have a shop manual?
if not ---get one it will be the single most powerful mod you can get for your trike.
Im into Yammis- so Im not familiar with your setup--but Im sure someone here can walk you thru it
Buy American! Unless your only option is a HARLEY.
A customer walked in to my shop and Impatiently stated "My car doesnt start, Whats the problem?"I responded with a smile-"Yep that sounds like your problem alright"----
New to the board
Arm chair racerNew to the board
is the seal from the outside or do you have to tear the whole motor down split the case.Whats the cheapest place to buy parts for these things brakes cables etc.
Power User
Got the holeshot
www.mfgsupply.com should have everything you need, then of course theres bikebandit.com and servicehonda.com
It shouldnt be too hard to fix your pullstart problem
If you need a copy of the 200m manual pm me, and ill send it to you through AIM or something.
1986 Tri-z
1985 250r
1985 200s
1985 70[/SIZE]
Power User
Lord of the trike
Are you sure it's oil ? and not dirty water ?
If it went thru deep water.. the pull handle does not always seal properly and lets water in..
Is your oil level low ? Once you drain it... check you oil... ride around.. DRY roads and check it again.. if you get more .. you have a problem.
Currently :
82 ATC - 200, plain jane, almost mint. ( Sold, 03-17-2005)
84 ATC - 200 ES, Jimmy-Rigged, don't ask.( Sold, 03-17-2005)
85 ATC - 250 SX, Pride and Joy, Bottom-Less Money Pit.
84 125 M - The Mini-SXnot running yet. but won't be long.
--
The more people i meet.. the more i like my DOG !
At The Back Of The Pack
Arm chair racerAt the back of the pack
good point they get full of dirt, then wet, the rope looks oily.
New to the board
Arm chair racerNew to the board
Its oil thats for sure.I loosened the pull rope and oil came out Im going to take the cover off and start it to see if oil is going in there.I just bought it maybe some one over filled the oil and it went past the seal is that possible.I will also drain the oil and put new in and it should stay full if not theres a problem.What oil should I put in the motor now for winter?
New to the board
Arm chair racerNew to the board
Also I just remembered theres a srew on top of where the pull rope is its bigger on top maybe the guy dumbed oil in there and thats why its full of oil is this possible
Power User
Lord of the trike
5w40 would be fine.
That big screw with the flathead type slot you are refering to i beleive is the timing hole.. wich leads to the flywheel, i do beleive there is oil in there normally anyways.. so no biggie there.
I have never heard of having an oil leak into the pull start before.. does not mean it's impossible i guess.. but yours would be a first for me.
Currently :
82 ATC - 200, plain jane, almost mint. ( Sold, 03-17-2005)
84 ATC - 200 ES, Jimmy-Rigged, don't ask.( Sold, 03-17-2005)
85 ATC - 250 SX, Pride and Joy, Bottom-Less Money Pit.
84 125 M - The Mini-SX
--
The more people i meet.. the more i like my DOG !
New to the board
Arm chair racerNew to the board
Thanks I will look at it tomorrow.Also did they make a front rack or something for the front fender where do you buy or what other models had one that would fit on my 200m
Just Too Addicted
Arm chair racerJust too addicted
Where are you from 67nova??? What part of WI?
Check vintagemotorsports.net for your rack, he may have one .
1983 250R ~ 1984 125M ~ 1990 POWER WHEELS!! trike
New to the board
Arm chair racerNew to the board
Im from Stevens
Point WI.I pulled the pull rope off today and started it up no oil leaking i drained the oil that was in there perfect now.Maybe someone overfilled the oil and it leaked past the seal.
Reply With Quote