my bet is that you messed something in the carb up, most likely the float that you replaced...
Power User
Got the holeshot
my bet is that you messed something in the carb up, most likely the float that you replaced...
1986 Tri-z
1985 250r
1985 200s
1985 70[/SIZE]
Got The Holeshot
Arm chair racerJust too addicted
maybe you should take it to a certified mechanic, all were doing is shooting in the dark, I have a hard time reading some of your posts about your problems, mainly because you use poor grammar and spelling, run-on sentances, etc...
I honestly think you should just load it up and take it to a mechanic, just tell him to do an estimate on it. When I do estimates at work, it takes me 15-25 minutes, so its about 30 bucks for an estimate (60 bucks an hour) It takes me, or the other mechanic about an hour and a half to fully clean the carb, that is letting them soak, complete disassemble, thorough cleaning, replacing any worn parts, and putting back together, and tunning.
With that said, if I was doing this at my shop, I would be charging you about 120.00 for the estimate, carb cleaning and tunning on the machine, plus an overall check of vavles, intake rubber, bearings, brakes, etc...
Curtis
Currently Trikeless- but I have a LT250R
Reply With Quote