How much would it cost to just bore, port and polish a 1985 250 Honda? Bore with no shaving or altering the jug or top end, just the bigger piston and rings.
Registered User
New to the board
How much would it cost to just bore, port and polish a 1985 250 Honda? Bore with no shaving or altering the jug or top end, just the bigger piston and rings.
Power User
Teaching quads a lesson
Alright, everywhere is different on this one. BUT here's a close approximation. Assuming your talking 250R here and not a 4 stroke, around $200 should get you a fresh bore and piston kit, which includes piston, rings, pin and clips. Then you'll need a gasket kit, that's another $20 or so.
Now, for port and polish. Getting this done is not basic machine work. It's an art, so expect to pay accordingly. I'm going to say $300 and up.
2007 YAMAHA YTZ450 went to a great home RIP Sam
New to the board
Arm chair racerNew to the board
I think you are confusing a "bore and hone" job with boring and porting and polishing. You want your cylinder bored and honed. This should be doable for $300.
Reply With Quote